Lanner FW-7565 Manuel d'utilisateur télécharger pdf (Page 17)

Motherboard Information

Chapter 3

Network Application Platforms

Hardware or Software Reset Jumper(JP2): The jumper

can be adjusted to be in either hardware or software

reset mode when the reset switch is pressed. The

hardware reset will reboot the system without turning

off the power. The software reset can be programmed

to reset a software to its default setting.

VGA Interface (J1): It is for connecting the VGA

interface cable.

Auxiliary Fan Connector (FAN3): This connector is for

connecting any additional cooling fans.

Jumper Settings

SO-DIMM Socket : It is for connecting the DDR2 667

memory (200 pin). Besides the 512MB/1G on-board

DDR2 667 SDRAM, the system can support up to a

total of 3GB.

Power Switch Connector(CONN2): This connector

is for the system power button. Pressing the power

button turns the system on or puts the system in sleep

or soft-off mode depending on the BIOS settings.

ATX Power Connector(PS1): The 8-pin connector is for

connecting ATX power supply plugs. Find the proper

orientation when inserting the plugs, for the supply

plugs are designed to fit these connectors in only one

orientation.

Fan Connectors(FAN1/FAN2): The 3-pin header is for

connecting the system and CPU fan. The BIOS will

list the CPU and system fans’ monitored temperature

and speed under the menu of Hardware Health

Configuration. You could also configure the target

temperature to adjust the fan speed automatically.

Front LCD Module Connector(J9): The 24-pin

connector is for connecting the front system panel.

Pin No. Pin name

1 PANSW

2 GND

3 2 1

Function Ground +12V Fan Status

PIN NO. 1 2 3

8 7 6 5 4 3 2 1

Function PSON 5VSB GND +3.3V +12V GND GND +5V

PIN NO. 8 7 6 5 4 3 2 1

23 21 19 17 15 13 11 9 7 5 3 1

24 22 20 18 16 14 12 10 8 6 4 2

GPIO GND K3 K1 LCD LPD7 Function

23 21 19 17 15 13 PIN No.

LPD5 LPD3 LPD1 LAFD- LSTIN- VCC Function

11 9 7 5 3 1 PIN No.

12 10 8 6 4 2 PIN No.

LPD4 LPD2 LPD0 LINIT- VEE IOGND FUNCTION

24 22 20 18 16 14

VCC3 VCC3 K4 K2 VCC LPD6

Pin No. Function

1-2 (Default) Software Reset

2-3 Hardware Reset

PIN No. 1 3 5 7 9 11

Function Red Green Blue HSYNC VSYNC DD_DATA

Function CRT ON GND GND GND GND DD_CLK

PIN No. 2 4 6 8 10 12

2 4 6 8 10 12

1 3 5 7 9 11

1 2 3

Function Ground +12V Fan Status

PIN NO. 1 2 3

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 51 52

Commentaires sur ces manuels

Pas de commentaire

Lanner FW-7565 Manuel d'utilisateur Page 17

Commentaires sur ces manuels

Produits connexes et manuels pour Matériel informatique Lanner FW-7565